Product Description
The Rheem Stellar Gas Hot Water Igniter Lead & Lead SIT SI0915066 is a replacement component for the Rheem Stellar series of gas hot water heaters. The igniter lead is part of the ignition system that is responsible for igniting the gas burner within the water heater, allowing it to heat the water efficiently. The SIT SI0915066 is the specific part number associated with this igniter lead.
Key Features:
-
Ignition System:
- The igniter lead is a critical part of the gas ignition system. It carries the electrical signal from the ignition module to the spark electrode, which creates the spark needed to ignite the gas inside the burner.
-
Compatibility:
- This specific igniter lead (SIT SI0915066) is designed for use in Rheem Stellar gas hot water heaters. It ensures that the heater's ignition system works correctly, allowing for reliable and efficient operation.
-
Durability:
- Built to withstand the high temperatures and demands of the water heating process, this igniter lead is constructed from durable materials to ensure a long lifespan and reliable performance.
-
Easy Replacement:
- The igniter lead is relatively easy to replace, especially if you’re familiar with gas hot water heaters. The part is designed to be a direct replacement for the original igniter lead, ensuring a seamless installation.
-
Part Number SIT SI0915066:
- This specific part number is used to identify the correct igniter lead for your Rheem Stellar hot water system. It's essential to verify the part number with your model before purchasing to ensure compatibility.
Common Symptoms of a Faulty Igniter Lead:
- No ignition: If your gas water heater is not igniting, it could be due to a faulty igniter lead. A broken or damaged igniter lead can prevent the spark electrode from receiving the necessary electrical signal to ignite the gas.
- Intermittent Ignition: If the heater sometimes ignites and other times does not, a damaged igniter lead could be the cause.
- Flame Failure: If the burner does not light or the flame goes out after a short period, the igniter lead may be malfunctioning.
- Error Codes: Some Rheem Stellar models may show error codes that indicate a problem with the ignition system, potentially caused by a faulty igniter lead.
Installation:
-
Turn Off Gas and Power: Before beginning, turn off the gas supply to the heater and disconnect the power (if electric) to ensure safety during installation.
-
Access the Ignition System:
- Open the access panel of the Rheem Stellar hot water heater to locate the igniter lead. This may require removing the front cover or another panel, depending on the model.
-
Disconnect the Old Igniter Lead:
- Disconnect the old igniter lead from the ignition module and spark electrode. Take note of the way the lead is connected so you can replicate the setup when installing the new part.
-
Install the New Igniter Lead:
- Attach the new SIT SI0915066 igniter lead to the ignition module and spark electrode in the same manner as the old one.
- Ensure the connections are secure and that the lead is routed in a way that it does not interfere with any other components.
-
Reassemble and Test:
- Once the new igniter lead is installed, reassemble the cover or panel, and restore the gas and power supply.
- Test the heater by turning it on and observing the ignition process. The burner should ignite smoothly, and the water heater should begin to operate as expected.